If you’re looking for the ultimate in tooling, you’ve found it! Amana Tool®'s PCD tipped compression CNC router bits will groove, joint and rabbet a wide variety of tough, abrasive materials including composites, particleboard, MDF (both raw or with melamine), veneer and hardwoods. The cutting edge lasts much longer than carbide for extremely long life. Depending on the material being cut, PCD tooling has been known to out perform a carbide tool by a ratio of 300:1. However, to be conservative in your buying decision, we suggest you base your expectations on 25:1 ratio over carbide tooling.
Excellent for cutting:
- Aluminum
- Aluminum Composite Material (ACM)
- Composite panels
- Custom composite materials
- Fiberglass
- Fiberglass PCB board
- Fiber-reinforced urethane
- Fiber-reinforced structural foam floors
- Lightweight composites
- MDF
- Plywood
- Plastic
- Hard and soft wood
Multipliers for different materials:Chipboard without coating: Max RPM x 1.1%Cross grain veneer: Max RPM x 0.7%MDF: Max RPM x 0.8%