If you’re looking for the ultimate in tooling, you’ve found it! Amana Tool®'s PCD tipped Straight Plunge router bits will cut a wide variety of tough, abrasive materials including composites, particle board, MDF (both raw or with melamine), plywood veneer and fiberglass. The cutting edge lasts much longer than carbide for extremely long life. Depending on the material being cut, PCD tooling has been known to out perform a carbide tool by a ratio of 300:1. However, to be conservative in your buying decision, we suggest you base your expectations on 25:1 ratio over carbide tooling.
Excellent for cutting:
- Aluminum
- Aluminum Composite Material (ACM)
- Composite panels
- Custom composite materials
- Fiberglass
- Fiber-reinforced composites
- Fiber-reinforced urethane
- Fiber-reinforced structural foam floors
- Laminate
- Lightweight composites
- MDF
- Particle board
- Plywood Veneer