Ogee Raised Panel Router Bits w/ Back Cutter

PRODUCT DETAILS

Click an item to expand and learn more

• Overview
  Back cutter=1/4" kerf, 5/16" radius cutter. Note: 'A' reflects the total length of cut. Therefore you must deduct (usually 3/8") for allowing the panel to recess into the frame. To receive 'A1' use bearing #47713, which is included.

  Similar to standard horizontal raised panel bits, but with back cutter to cut inside of the panel. Includes two different bearings to allow for safer two-pass operation. Carbide Tipped. Use with router table only.
  
  

  Watch now! How to make Raised Panel Doors Amana Tool Building a Raised Panel Cabinet Door

  ?WARNING! For Your Safety 1. The methods illustrated here are only intended for use with a table mounted router. 2. Do not exceed the recommended RPM for each of the bits. 3. Use a miter gauge and clamp when routing the ends of the rails. 4. Use a push block or push stick when routing the door styles. 5. Use a guard at all times. 6. Use eye and hearing protection. 7. Do not use the methods in this set of instructions unless you feel that they are safe for you. Router Bits shown in video Stile & Rail Router Bits Reversible Stile & Rail Assembly - #55350 2pc Concave Stile & Rail - #55420 & #55421 Raised Panel Router Bits Ogee Raised Panel - #54118 Ogee Raised Panel w/Back Cutter - #54221

• Reviews
• Questions and Answers
• CA Prop 65 Warning
  

  WARNING: Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood.