CNC Polycrystalline Diamond (PCD) Compression Router Bit Up/Down Shear with Carbide Plunge Point RH Rotation

PRODUCT DETAILS

Click an item to expand and learn more

• Overview
  Note: #DRB-260 Body for special hard steel or DENSIMET®. #DRB-228 and #DRB-232 are replaced by #DRB-224.

  For CNC Use Only. 
  
  Diamond is the hardest material on the earth. Polycrystalline Diamond (PCD) tooling is manufactured in a high-temperature and high-pressure laboratory that fuses diamond particles onto a carbide substrate, which allows the diamond to be brazed onto a tool body. 
  
  
  PCD Tooling Benefits:

  • Harder cutting edge provides higher resistance to wear
  • Cut thousands of feet more than carbide without changing tool, saving setup time

  • Optimized machine tool efficiency
  • Quality of finish is often significantly improved

  If you’re looking for the ultimate in tooling, you’ve found it! Amana Tool®'s PCD tipped compression CNC router bits will groove, joint and rabbet a wide variety of tough, abrasive materials including composites, particleboard, MDF (both raw or with melamine), veneer and hardwoods.

   

  The cutting edge lasts much longer than carbide for extremely long life. Depending on the material being cut, PCD tooling has been known to out perform a carbide tool by a ratio of 300:1. However, to be conservative in your buying decision, we suggest you base your expectations on 25:1 ratio over carbide tooling.
  
  

  Excellent for cutting:

  • Aluminum
  • Aluminum Composite Material (ACM)
  • Composite panels
  • Custom composite materials
  • Fiberglass

  • Fiberglass PCB board
  • Fiber-reinforced urethane
  • Fiber-reinforced structural foam floors
  • Lightweight composites

  • MDF
  • Plywood
  • Plastic
  • Hard and soft wood

  Multipliers for different materials:

  Chipboard without coating: Max RPM x 1.1%
  Cross grain veneer: Max RPM x 0.7%
  MDF: Max RPM x 0.8%. 

   

  Note: #DRB-190 is made with hard metal tool body.
• Reviews
• Questions and Answers
• Videos

  Fin Lockers CNC Project in Birch Plywood

• CA Prop 65 Warning
  

  WARNING: Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood.