WARNING! The max RPM for the 61299 Dynamically Balanced non Random Orbital Sander is 8,000. Working with higher rotation speed can cause damage to the machine spindle.
Please note: After one hour of sanding, stop and turn the power off on your CNC machine. Inspect to ensure the tool spins freely. Repeat after each hour of sanding.
PAD INSTALLATION & REPLACEMENT
1. Hold the spindle with the key (part #6) using the flats on the spindle.
2. Remove spindle (part #2), ring (part #3) and spring (part #4).
3. Clean out any dust and swap the spring if necessary (part #4).
4. Reassemble ensuring the ring (part # 3) is installed with the groove seated toward the top bearing of the spindle (part #2).
5. Press the spindle into housing, and tighten the screw (part #1).
6. (Part #5) helps to balance the tool. It is properly adjusted from the factory, do NOT attempt to remove it!
The max RPM for the 61299 Dynamically Balanced non Random Orbital Sander is 8,000. Working with higher rotation speed can cause damage to the machine spindle.